Twin Extruder Calibration

MakerBot Replicator 1 Calibrating/Aligning Nozzles (X and Y directions)
Calibration of Nozzles for twin extrusion This article relates to : Replicator 1 (Ply wood) twin and the 2X Specifically :                 ...
Wed, 8 Jun, 2016 at 2:13 PM
Makerbot Replicator 2X : Calibrating/Aligning Nozzles (X and Y directions)
Calibration of Nozzles for twin extrusion This article relates to : Replicator 1 (Ply wood) twin and the 2X Specifically :              ...
Wed, 8 Jun, 2016 at 9:40 PM
Makerbot Replicator 2X - Does not know I have 2 extruders
Makerbot Replicator 2X - Does not know I have 2 extruders Most commonly when you upgrade Firmware often the Replicator 2X defaults back to a REplicato...
Thu, 20 Nov, 2014 at 5:03 PM
Calibration of Nozzles in X and Y axis
About Twin Extruder Nozzle Alignment When the extruders are not aligned you end up with prints like those pictured right, where one nozzle...
Thu, 4 Feb, 2016 at 3:23 PM
Calibrating nozzles on the Flashforge DReamer : Correcting Z height
Symptoms While doing dual extruder prints one head is too high/low and causes either filament to squash into the layers of another (too low) or the sec...
Thu, 4 Feb, 2016 at 6:18 PM